KVAL COMMANDER

 

 

PRICE: Call for Pricing 


 This machine has had most of the available updates added to it
High Frequency Router / Overhead back section adjusting handle / Quick hinge power sourcebar changing / Nylotrac housing for power source

         This machine requires 220 volt three phase 34.9 amps
120 volt single phase 20 amps
Foot Print 9 ft. X 14-1/2 ft.
Shipping 164 in. long X 82 in. wide X 67 in. high   4,500 lbs

Capabilities: Rout and bores for lock and hinges in flush or stile and rail doors up to 2-1/4″ thick x 4′ x  9′ long, minimum width 16″.  Also accommodates raised
panels or moulding up to 3/4″ thick.  The jamb clamping system compensates for jamb thickness and will accept flat, split and rabbeted jambs up to 1-1/4″ thk.
with a 5/8″ stop  ( 1-7/8″ thick overall ) There is no limitation to jamb width.

Hinge Routing: Automatic hinge routing unit accommodates both 1/4″ and 5/8″ radius hinges up to 5-1/2″ with turret stop adjustments. Hinge Centers are
adjusted by positioning collars on a removable shaft below the router, and sliding the jamb clamping fixtures into position.
Extra shafts can be set up and ” plugged in” for rapid hinge center adjustment.
During the routing sequence the router automatically travels to each collar positions and dapps the pocket. Full hinges up to 4″ x 4″ can be attached to the
door and jamb.

Lock: Face bore adjustable from 2-3/8″ to 5″  backset.  Faceplate is adjustable for square or bevel doors up to 3 1/2 degree.  From 1″x 2-1/4″ up to 1-1/4″ x
12″.  Self centering clamp system insures accurate latch and faceplate machining regardless of door thickness.  face bore motor is 5 hp. 3450 RPM, and
faceplate uses  1-3/4 hp. heavy duty router.  Both drill motors feature Accu-Flex collet chucks so standard straight shank tooling can be used.